Baileigh Metal Forming Shrinker Stretcher Mss-14H

Unique on the market, our patented* hydraulic shrinker stretcher lets you shape thick sheet metal at amazing speeds. Foot pedal operation and magnetic tooling also save you time.

• This Baileigh shrinker stretcher is made in the USA.
• 14 gauge mild steel and 12 gauge aluminum capacity.
• Runs on 110-volt single-phase power, so you can use it anywhere.
• 7” throat enables you to work deep into a piece of sheet metal.
• Hydraulic/pneumatic system drives 30 to 40 strokes per minute.
• Hydraulic downstroke delivers greater power than a manual model could, while the air pressure-assisted upstroke moves faster.
• Foot pedal control allows for hands-free operation.
• Comes standard with a set of 4 quick-change magnetic jaws.
• You can switch between shrinking and stretching in seconds simply by turning the jaws around.
• Turn the wheel on top of the shrinker stretcher to adjust the jaw gap.
• Solid plate steel frame gives the machine enough structural strength to stay accurate at maximum capacity for many years.
• We cover this metal shrinker stretcher machine1-year parts warranty.
• You can depend on lifetime technical support by phone from our team of reps, all with hands-on machine experience.
• Shrinker stretcher arrives fully assembled. Just plug it in and go.
• Replacement jaws and other parts are in stock, so we can ship them to you without delay.
• Save money by sending the jaws to us for resurfacing. No need to buy new jaws every time they wear down!

Recommended for: Any automotive, aeronautical, or metalworking shop that does a lot of shrinking and stretching and needs to work with thick material.

Note: To run the MSS-14H, you’ll need an air compressor, available at most hardware stores. The size of the compressor depends on how often you plan to use the machine.